Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community  |
Calendar | Become a Paid Member | Today's Posts | Search |
|
|
|
Thread Tools
|
Display Modes
|
|
#1
12-24-2007, 04:20 AM
|
|||
|
|||
67 68 BB Muncie shifter stabilizer rod
I picked one up but I'm not sure if it's the right one. Does anyone have one with exact measurements? This one has about 1/4 inch bend. Overall length is 9 inches. If you measure from the integral hex nut to the slot, it's 5 3/8 inches. The SB Muncie stabilizer I have measures 6 inches. This seems to make sense with the BB setting back further than the SB and the cross-member where the shifter mounts staying in the same location.
Would love to know if I finally got the right piece to complete my shifter.
__________________
Martin Foltz 68 Camaro SS-396 L35/M20, Corvette Bronze, black vinyl top George Olsen Chevrolet San Francisco 
|
|
#2
12-24-2007, 11:03 PM
|
|||
|
|||
|
Re: 67 68 BB Muncie shifter stabilizer rod
Martin,
The overall lenght is 10.5 inches. From the hex nut to the slot is approx. 6.5 inches. The off-set (bend) is approx. 7/8 inch. The BB rod and linkages are very hard to find. I restored OEM Muncie shifters for many years but no longer do it. However, I have kept tracings of the various rods, shafts and levers for reference. Hope this helps.
__________________
Craig S. "I saw Elvis At 1000 Feet" John Force.
|
|
|
|
Linear Mode
