69 X-11 Style Trim Fender & Qtr Panel Pin Stripes

[CamarosRus]

Is it correct that all X-11 Style Trim 69 Camaros have Fender and Qtr Panel Pin Striping. Can someone link me to where I might get CORRECT/ACCURATE pics or dimensions of how to replicate this striping....

Thanks,

[Enoch]

Chuck, the specks are in the 69 assembly manual I'll look it up and tell you what page later.

[Mark_C]

Not if the car was a small block SS. Only one stripe package allowed per car, so if you had a D90, or Dx1 stripe you couldn't get the D96's. The Z10's, Z11's are the exception, as are some RS Z28's. Think it was possible on early Z's but not latter ones. William will know for sure.

The stripes were painted by hand with a thin steel template (mask) at the factory, I beleive it was done in the trim shop after the front end was assembled to the rear tub.

[CamarosRus]

Hello to all, I have been kindly sent the assy manual page showing ALL the D96 stripe specs. Hopefully I can find a talented local pinstriper to replicate these.
1) Can someone send me/link me GOOD pictures of survior D-96 stripes to show pin striper
2) Any guesstimate as to how common X-11's (COPO's) were with D96 stripes????

Thanks

[69L72RS]

Chuck,
I will send you some pics from my Z10 and my COPO.
Later,
Eric