|
|
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
|
|
|
Thread Tools | Display Modes |
|
#1
04-19-2005, 04:33 AM
|
|||
|
|||
upper/lower control arm pics
Here are some pics of the upper/lower control arms for my ls6 that I am putting back together, those are nos ball joints and control arm bushings,what a pain to locate!!!
|
|
#4
04-19-2005, 04:38 AM
|
|||
|
|||
|
Re: upper/lower control arm pics
last one, sorry about the quality of the pics,this particular camera is not the best,but my better gives me fits when I try to post pics.I'll post more of the lower when I take off the masking tape.
|
|
#5
04-19-2005, 05:29 PM
|
||||
|
||||
|
Re: upper/lower control arm pics
Looks good, I am getting ready to do the same on my 68 GTO
Did you rivet in the Ball joint before or after painting?
__________________
~JAG~ NCRS#65120 68 GTO HO 4 spd Alpine Blue /Parchment 2 owner car #21783 71 Corvette LT1 45k miles Orig paint - Brandshatch Green - National Top Flight - last known 71 LT1 built. 71 Corvette LT1 42k miles Original paint - Black - black leather - only black LT1 known to exist. NUMEROUS Lemans blue Camaros, Monza Red and Daytona Yellow Corvettes & a Chevelle or two... Survivors, restored cars, & other photos https://picasaweb.google.com/lh/myphotos
|
|
#6
04-19-2005, 06:56 PM
|
|||
|
|||
|
Re: upper/lower control arm pics
I primed/painted after the ball joints and bushings were put in, good thing I did as there were quite a few marks on them from the machine shop.I can't see how the marks could be avoided,it's not that bad of a job to mask everything off.I used about a 80% gloss black on the arms as compared to 60% on the frame itself.The cross shafts were blasted,rinsed with metal prep then scuffed up with a red scotchbrite pad,I'll then coat them in boeshield to keep them from rusting.
|
|
|
|
Linear Mode
