Fender Badges, 68 Camaro

mudjnky · #1 03-07-2007, 11:17 PM

Is there a template anywhere for the placement of the "Camaro" and "SS" emblems? I think mine are in the wrong spot and want to double check before I put the stripe on. Thanks!

**Dave Rifkin** · #2 03-08-2007, 01:09 AM

I'm pretty sure the Assembly Manual has fairly detailed measurements for the proper placement of the emblems.

68l30 · #3 03-08-2007, 05:16 AM

The book can get you pretty close....I never really trusted it though...I found a few orig paint SS cars for the stripe dimensions and used ref locations off of those for the "Camaro" script..Same with the 327 numbers...Be sure the stripes are correct..most are terrible.

Steve

P.J. · #4 03-08-2007, 05:44 AM

They sell a complete milar stripe and emblem Kit at your local clasic car store. The side marker emblem is in the kit.
Peter

mudjnky · #5 03-08-2007, 06:39 PM

I was going to buy a stencil kit from Phoenix Graphix for the stripe. Does anyone have a good shot of the emblems in the right spot?

68l30 · #6 03-08-2007, 08:09 PM

I have them at home......I'll dig them out later..

Steve

mudjnky · #7 03-08-2007, 08:32 PM

[ QUOTE ]
I have them at home......I'll dig them out later..

Steve

[/ QUOTE ]

Thanks Steve!

68l30 · #8 03-09-2007, 04:42 AM

Ok....Here's a unrestored 68.....

Steve

68l30 · #9 03-09-2007, 04:44 AM

Same car top of header panel....

68l30 · #10 03-09-2007, 04:49 AM

Here is a restored 68....Not a terrible stripe job by any means....just a little fatter...Notice the SS sits a bit higher in the stripe.Also the stripe leads out of the wheel opening a bit closer to the edge..427 is a tad high as well..

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.