![]() |
|
Register | Album Gallery | Thread Gallery | FAQ | Community | Calendar | Become a Paid Member | Today's Posts | Search |
![]() |
|
Thread Tools | Display Modes |
#2
|
||||
|
||||
![]()
Depending on where in CT you are, Westchester Wheel Repair in Verplank (near Indian Point) does a really nice job on straightening wheels. State of the art equipment too.
__________________
Follow me on Instagram: https://www.instagram.com/mbcgarage/ |
The Following User Says Thank You to MosportGreen66 For This Useful Post: | ||
RPOLS3 (Yesterday) |
#3
|
|||
|
|||
![]()
trying to determine bad new tires or wheel
|
#4
|
|||
|
|||
![]()
For starters, I've thrown out (I mean literally scrapped for weight) MANY sets of 1980's 14" Cutlass "styled steel wheels" as well as two full sets of 1980 Z28 steel five-spoke wheels. I had a wobble in three different cars (all running factory "styled steel" wheels) and was finally able to narrow my wobbles down to bent steel wheels (I built my own wheel checker using an old steering knuckle/spindle, brake rotor and dial indicator). I now run aluminum wheels.
That being said, if all you want is an assessment of tires/rims, not an actual repair of steel wheels (at this point you don't know you need a repair), take your tires/rims to any tire shop (one that is willing to work with you), have them remove the tires then have them spin the bare wheels on their balancer. Be present when they are spun. If a wheel/rim is bent, it will be obvious. If all the wheels run true, it's most likely your tires (or driveshaft balance, or u-joint or ...). Last edited by useless tony; Today at 04:29 PM. |
![]() |
|
|