Thread
:
Canuck and Edgemont Villages new Shop
View Single Post
#
265
04-19-2020, 01:43 AM
Edgemontvillage
Yenko Contributing Member
Join Date: Mar 2011
Location: Vancouver
Posts: 651
Thanks: 91
Thanked 349 Times in 122 Posts
Now that the open-end of the blasting shed is enclosed and weatherized we turned our attention to interior finishing. To clean, seal and brighten the travel weary half-container we gave it a couple of coats of KILZ primer which adheres well and covers everything. As we had already laid new T&G plywood floors and applied joint filler-sealer (and sanded it) we decided to install 60mil exterior vinyl decking for durability. The vinyl was cut to measure then adhesive was rolled onto the fuzzy backing and the plywood flooring, booked, allowed to set up then applied and rolled smooth - a lot like hanging wallpaper actually. Everything but the seam sealer was completed. Would have got to that save for the Olfa knife incident...it will have to wait for another day.
We had a warm day for the job so the vinyl was left out to absorb some heat to make it more pliable.
One step closer
Last edited by Edgemontvillage; 04-19-2020 at
01:47 AM
.
The Following User Says Thank You to Edgemontvillage For This Useful Post:
HawkX66
(04-20-2020)
Edgemontvillage
View Public Profile
Find all posts by Edgemontvillage