[Too Many Projects]

Monday, I was burning off the remnants of an old, brazed on, patch when I realized I had my lower door brace welded to a panel I had to replace...





I cut another tube and moved it back and up on the vent panel.





This is the replacement part.











In the process of doing that, I was wire wheeling the area and found rust damage in the toe board and pillar. That was to be Tuesdays work.






I cut the toe pan out and made a tag board template and then rough cut a piece of sheet steel.











I then bent the weld flange and used the stretcher jaws to give the piece some curvature to match the floor.











I didn't take any pics of the pillar patch, but here they are drill screwed in place for floor pan test fit.