Thanks! Not many comment so I'm never sure if its worth continuing the thread at times. But I just try to keep marching through all the small projects that will hopefully end with a completed major project.
Next updates are the reassembly process for the firewall components, harness, dash items etc. All in all everything is gong back together smoothly.
Photos 542 - 546 - Fuse block installed, along with gas pedal and throttle arm.
Photos 547 - 548 - Next were the Astro Vent duct work and the bezels & balls
Photos 549 - 551 - Using my Harbor Freight special da polisher I run over the dash face with some Mequiars 105 since I had previously had #7 soaked into the paint prior.
Photos 552 - 555 - Installation of the drop down brackets, pedal assembly and clutch rod along with its boot.
Photos 556 - 559 - Dimmer switch, ignition, headlight, wiper and cig lighter switches installed
Photo 560 - Shot from the outside of firewall. Also installed correct 4 rib washer nozzle hoses.
Complete steering column teardown and go through hopefully in the next couple of weeks.
Last edited by cook_dw; 03-27-2023 at 01:30 PM.
|