Thread: Blackjack Headers
View Single Post
  #5  
Old 10-20-2021, 01:32 AM
rszmjt rszmjt is offline
Senior Member
  
Join Date: Nov 2004
Location: Calgary,Alberta,Canada
Posts: 263
Thanks: 5
Thanked 117 Times in 77 Posts
Default
Quote:
Originally Posted by Chuck_Burg View Post
Hi Kurt! Those look identical to my Appliance CH4s, which are for 67-69 Camaro. You can see mine on my build thread.

https://www.yenko.net/forum/showthread.php?t=161440
Chuck, I think your 100% correct, before Appliance headers changed to Blackjack the CH4 number was used, pretty sure the blackjack number is 3017, same header later issue.

I put a lot of those Appliance headers on in the early 70,s when I worked at a local Calgary speedshop JB,s Automotive , very nice headers very equal length too. I have a set of CH3 headers for a small block Camaro been saving them for years. FWIW when Blackjack took over they changed to that rotating lower flange.
Last edited by rszmjt; 10-20-2021 at 01:34 AM.
Reply With Quote
The Following 2 Users Say Thank You to rszmjt For This Useful Post:
69 Post Sedan (10-20-2021), NorCam (10-20-2021)