View Single Post
  #8  
Old 04-20-2008, 08:29 AM
Nova Jed Nova Jed is offline
Senior Member
 
Join Date: Oct 2007
Location: Gibraltar
Posts: 2,095
Thanks: 0
Thanked 1 Time in 1 Post
Default Re: If there is one thing that doing my first,,,

I'm sure a couple of other body men and do-it-yourselfers can chime in on this one as well. I have done a 69 Camaro, a 55 Bel-Air, a 71 Chevelle, and of course, a couple of Nova's. I don't think that there wasn't one panel that fit just right and I know a lot of people gripe about "bondo", but that's how you have to "make them fit". 80% of my 69 Camaro is repop sheetmetal and the doors were a full inch shorter then the originals. Now how does that happen if the supplier to Goodmark is using the right tooling? Didn't they ever check them against originals? And yes I had the quarters mated with the doors on in the original position. Atleast that is how I was taught to put quarters on. When I took the old door off and put the new one on, there was more then a half inch gap on the quarter side and the same at the fender.

The only stuff the fit well, on the repop side, was the stuff for the 55 and I bought all of that metal from CARS Inc. I have been finding out that the stuff for the Novas isn't all that bad. The Chevelle stuff, for me, had fit rather nicely! Go figure?
__________________

Jed 69,70,71 Nova's 1955 Bel Air and a 69 Camaro.
Reply With Quote