Thread: Aluminum intake finish
View Single Post
  #5  
Old 01-10-2008, 09:57 PM
MosportGreen66's Avatar
MosportGreen66 MosportGreen66 is offline
Yenko Contributing Member
  
Join Date: Nov 2002
Location: NY, NY
Posts: 8,722
Thanks: 1,091
Thanked 1,039 Times in 462 Posts
Default Re: Aluminum intake finish
[ QUOTE ]
My 569 was pretty krusty when I got it. I had it blasted first then I followed the advice of Kwhizz and Cumby and used the Eagle Mag Wheel Etching Cleaner. I took a full bottle and the intake to my local manual car wash and soaked it with the cleaner, let it sit a bit and then powered washed it clean. I did this a few times till the finish looked even. Then after it dried real good I took a fine green scotch brite pad and buff it out. I think it turned out great. Let me see if I can dig up some pictures...

[/ QUOTE ]

great advice!
__________________
Follow me on Instagram: https://www.instagram.com/mbcgarage/
Reply With Quote