[A12pilot]

More blocking, more sanding. Block, block, block....sand, sand, sand. Where's Mikey?

I had my neighbor 3D print some plastic rings that will insert into my gauge bezel. These will allow easy gauge mounting and will recess the faces of the gauges just enough to be even with the top of the bezel. I'll all some trim rings around the edge and it should look perfect.








Door shells are about done, so more pics next week! Lots of work this past month but you can only post so many pics of block sanding before you lose the interest of the audience. I'm already bored!





Radiator with horns mounted too. Identical to the factory!




Cheers
Dave