Strangely, I did check the gauge again for power where it comes out of the gauge, but when I ground the power lead going to the sender, it sweeps the gauge.
One of two scenarios.
1. I do not know how to properly use a test light.
2. The Sun gauge works a bit differently than stock arrangements.
On the bright side, the gauge appears to be good. The downside is the sender for these is tough to find.
At any rate, the problem is solved for now. Thanks to everyone who took the time and effort.
Tim
Last edited by napa68; 02-12-2023 at 09:29 AM.
|