[Lynn]

Have a gantry crane that is really handy. 10 x better than a cherry picker for pulling and installing engines.

But... it wasn't quite wide enough to fit either my car hauler trailer or my 49 Studebaker dump truck under it. Couldn't find a small I beam to replace the 9 footer. So, I bought some 1/4 inch thick 3 inch angle iron. Already had some 1/4 inch thick steel plate in 20 foot lengths. Cut pieces to 130 inches long. Welded the plate between two pieces of the angle iron. Then I welded on two end plates cut from the end or some C channel I had left over from a previous project. That means the new "web" is 3/4 inch thick. A bit of overkill, but it is what I had available.

Got it done last Sunday. The pics will probably post sideways, as they were taken on my cell phone. Even though I load them on my computer and rotate before downsizing and saving, they still come out sideways most of the time.