03-07-2022, 12:52 PM
|
 |
Yenko Contributing Member
|
|
Join Date: May 2009
Location: Rockford, IL area
Posts: 3,678
Thanks: 6,497
Thanked 3,295 Times in 1,096 Posts
|
|
OK - so some good things happening already this morning. On my way into the office I stopped by my buddies shop for some advice. He tapped the valve lightly with a dead blow hammer after shooting some compressed air into the port and the piston centered on its own. I installed the centering tool to hold it in position.
Now back to the drawing board to install the assembly for the 3rd time and bleed everything.
Progress.........hopefully
|