Hi, Steve!
Yes! After, lo, these many years, ’tis I. Having been “RA” (Restoration Assistant) to ya back in the day on several of yer stellar vehicles, perhaps I can, on occasion, be yer “RAFA” (Restoration Assistant From Afar) on this here project! (No matter what, at least I can experience it vicariously through your exemplary photo & text documentation!) My perpetually busy schedule is a little less perpetually-busy, so I thought that I’d join y’all. Kudos to ya (and, of course, Dave) on the ‘cuda!
I scrolled through the last 20, or, so pages, and, perhaps I can render an assist about a coupla’ semi-recent inquiries which you posed.
#701 p. 71 Re: The ground straps for the Shaker air doors, I just checked both my early (Aug./Sept. ’70 Printing) -&- Late/Final (Dec. ’71/Jan. ’72) ’70’/’71 Parts Catalogs, hoping to glean some info, however, it appears that they are not serviced. Perhaps it’s the “Mad Scientist” in me, and, I hasten to point out, sheer speculation, however, considering it’s “arcane engineering Chrysler” here, I wonder of they’re to prevent the driver and/or the dash from getting zapped from a direct lighting strike to the bubble through the shaker cable?! Hmmm…
#707 p. 71 Re: Glass Codes
AS2 = Tempered Glass w/ 70% light passage; non windshield
M27.7 = Model # used by the glass manufacturer; in this case PPG (as mandated by US Law)
26.99 = *Sept. 1969
26.79 = *July 1969
DOT18 = PPG Industries / Pittsburgh, PA. USA
*Not sure of “26” That number appears on the original glass of both my right & left doors of my ‘71 Charger / All other info is complete & correct
#755 p. 76: …And, Re: The jute backing separator board direction of orientation, to be properly installed the jute faces the luggage compartment (aka “The Trunk"). The caveat here is that it “shouldn’t” be installed in a 340 ‘cuda, ‘cause that was “only” used on Gran Coupe models, however, as we often say, “It’s Chrysler,” and (almost) anything is possible. (As a note, that, also, would have been installed on any Challenger SE, or, R/T/SE. My previous ’71 Charger SE included factory-installed jute-backed package shelf -&- passenger/luggage compartment separator panel, and, carpet trunk mat & spare tire cover, as well as clip-in color-keyed cardboard panels to cover the wheelhouses & the inside quarter panels.)
I hope that this helps! MoPar to ya!
PS This is my first time on this Forum, so apologies if I didn’t post correctly!
|