Quote:
Originally Posted by Keith Seymore
Why couldn't a person move the leading edge of the door outboard to match?
K
|
At the factory The door hinges were located on the end of the door using a fixture which indexed the hinge to the outside profile of the door skin in order to align with the Quarter panel profile properly.
IF you tilt it out at the top- the profile will be fat in relation to the quarter panel.
If you move the leading edge out from the body in it's entirety will the door and rocker still be in alignment, can you get your seal good enough PLUS will you create too much gap at your wiper cowl to fender gap?
__________________
~JAG~
NCRS#65120
68 GTO HO 4 spd Alpine Blue /Parchment 2 owner car
#21783 71 Corvette LT1 45k miles Orig paint - Brandshatch Green - National Top Flight - last known 71 LT1 built.
71 Corvette LT1 42k miles Original paint - Black - black leather - only black LT1 known to exist.
NUMEROUS Lemans blue Camaros,
Monza Red and Daytona Yellow Corvettes
& a Chevelle or two...
Survivors, restored cars, & other photos
https://picasaweb.google.com/lh/myphotos