Moser serviced my housing with welding new perches on them and didn't do a good job many years ago. Plus I'm not impressed with the Moser imported perches. Didn't notice or find out until I dropped the rear unto springs. Because they didn't have one of the perches welded at the proper 2 degrees off center the outside edge of the springs under the perch pocket were binding or rubbing against the inside wall of the perches. Plus one side where the perch is welded to the tube is leaking rear end fluid slowly if you can believe it. I am very familiar with Wzorek Automotive. He doesn't do welding but is excellent when it comes to setting up rear ends. Have to find someone with a jig or a experienced welder that's for sure. I do have a donor rear that I can remove the originals from and then clean up for welding. The 2 degree angle is important.
|