Re: Commercial parts tumbler
my machine shop doesnt have a tumbler section of it..he never had it..so..not sure its mandatory, especially on the stuff you would be doing..and the extra space it would take
trust me when i say any metal that goes in comes out incredibly nice..
only thing, never run alum and iron together..its muddles the alum finish and can turn grey or have a red tint from the rust of the iron..
a rear housing fits barely..in his he did my 66 chevelle 12 bolt....i will be there next week and will measure his width and the foot print of both pieces..and ask if he has a figure on what it actually cost to run a batch.
i want one..just dont need it..but man.i want one..
__________________
Mark
|