Thread: Machinist's advice sought
View Single Post
  #8  
Old 08-26-2016, 01:03 AM
68l30's Avatar
68l30 68l30 is offline
Senior Member
  
Join Date: Sep 2000
Location: "Skinny lil boy from Cle Ohio"
Posts: 3,350
Thanks: 60
Thanked 91 Times in 43 Posts
Default Re: Machinist's advice sought
Had a stud issue like above on a set of 462's. I should have been running screw in studs. Have the mount milled down and threaded for screw in studs. Mag the boss after machining to make sure the crack is gone. The pin hole SHOULD have stopped the crack, I would be surprised if it went below the hole.

BIG
Reply With Quote