View Single Post
  #7  
Old 10-07-2010, 01:35 AM
olredalert olredalert is offline
Yenko Contributing Member
 
Join Date: Dec 2002
Location: Marine City, Mi.
Posts: 9,362
Thanks: 32,420
Thanked 4,457 Times in 1,898 Posts
Default Re: LT1 compared to L79


----While this is off the beam a bit it does have some relevance.
----When I first took over the "Red Alert" helm in 1990 the car hadnt been changed substantially since Bob H had run it. He ran that 3980lbs 70 LS6 SS/DA Chevelle with 5:88s thru the quarter. Someone else can figure out the RPMs with a 33 inch tall tire, but I knew I didnt want to run the car thru the traps at anywhere near that RPM. Point being,,,A good light weight bottom end is everything. Keep the rods attached to the crank and you can twist almost any motor tight. Well built small-blocks have a built in edge (low reciprocating weight), and almost any HP small-block can make big RPM with that in mind. Big-blocks can also reap those same benefits when the reciprocating assembly is built light and the stroke is believeable.......Bill S
Reply With Quote