Edelbrock C-396 manifold..
 

Anyone got one of these kicking around..???

wilma

Re: Edelbrock C-396 manifold..
 

I do but its on a car, I have a C427X thats availible. https://www.yenko.net/ubbthreads/imag...lins/beers.gif

Re: Edelbrock C-396 manifold..
 

Isn't that the rect. port with the offset..it came before the Tarantula..??
wilma

Re: Edelbrock C-396 manifold..
 

I have (had) one .... until the guy's check clears, then it's getting shipped out.

I could put you in touch with the guy I'm sending it to if ya want?



Tom

Re: Edelbrock C-396 manifold..
 

[ QUOTE ]
Isn't that the rect. port with the offset..it came before the Tarantula..??
wilma

[/ QUOTE ]
That would be correct Wilma. You can always match port your heads to the intake... https://www.yenko.net/ubbthreads/imag...ns/naughty.gif

Re: Edelbrock C-396 manifold..
 

[ QUOTE ]
Isn't that the rect. port with the offset..it came before the Tarantula..??
wilma

[/ QUOTE ] A tarantula is a spider, not an intake manifold. https://www.yenko.net/ubbthreads/imag...s/confused.gif https://www.yenko.net/ubbthreads/images/graemlins/no.gif

Re: Edelbrock C-396 manifold..
 

I sold one to a member here sometime last year. Not sure he used (or will use) it...

Re: Edelbrock C-396 manifold..
 

is this what you're looking for? Crash
[email protected]

Re: Edelbrock C-396 manifold..
 

Thats it... https://www.yenko.net/ubbthreads/imag...lins/beers.gif

Re: Edelbrock C-396 manifold..
 

I'll chime in on this one also. The C427X does NOT have the offset carb. It is a dual plane configuration with the plenum notched out. Basically it is Edelbrocks' version or the Chevrolet L-88 intake manifold. The Tarantula or TM2R is the one with the canted carb to correct the BBC's handicap of 4 good intake ports and 4 bad intake ports.