1970 L-78 / LS-6 part(s) WANTED & Comments
 

Below is assy manual page for 1970 Camaro. I am seeking the two clips supporting PVC Hose, Original PVC Hose, Original Smog Hoses and ANY other Smog related parts that you might know of someone having. Mr Hoedel supplies reproduction hoses and doesnt have the clips.

RARE Metal Clips along with PVC hose are shown. I have also pointed out the left side Metal Tube "Tree" configuration which differs from the as-built
I am also looking for the two ORIGINAL Hoses coming from the 992 Check Valves to the 297 Divertor Valve.....

http://img.photobucket.com/albums/v4...tails/Air1.jpg

Re: 1970 L-78 / LS-6 part(s) WANTED & Comments
 

They used the same diagram in the 1970 Chevelle Assembly manual for the L78 Chevelle.That "Smog Tree" configuration was offered in two designs for the Solid lifter Chevelle.Early versions (Dec./Jan.) received the "Hockey stick" design,with later(Jan./Feb.) getting the design where the valve was connected in the lower middle of the Valve cover,which appears to be wthe design your diagram shows.

I hope you can find those Dual Snorkle PCV Rare clips,and share a picture with us. https://www.yenko.net/ubbthreads/imag...iggthumpup.gif

Re: 1970 L-78 / LS-6 part(s) WANTED & Comments
 

Mr 70, So should I assume that ALL the L-78 Camaros built from January 1970 forward would have had the left hand pipe shown above. Another 70 Camaro assy page L78/A9 shows the "Hockey Stick" pipe, which contradicts the above.
I do not know of anyone having an ORIGINAL (born with) Smog System on there 70 Camaro L-78 to reference too. It seems that everyone having restored a 70 L-78 Camaro A.I.R. system has used the repop Hockey Stick tree or possibly survivor Chevelle or Nova hockey stick trees.......
Thanks, Chuck

Re: 1970 L-78 / LS-6 part(s) WANTED & Comments
 

With only 600 1970 L78 Camaros made,it's a hard question to answer.
I would "think" the majority of the 1970 L78 Camaros received the LATER design tube,not the 1969 Early 1970 L78/LS6 Hockey stick design.Both of these Configurations have been reproduced.
What is the revision date on those L78/A9 pages in your Ass. Manual??

Re: 1970 L-78 / LS-6 part(s) WANTED & Comments
 

GOOD LUCK Chuck,
It took me years to get (1) set of those clips for our dual snorkel LS-6 Chevelle. Would like another set myself. If I hear of any clips coming, I will let you know.
The "MOF"

Re: 1970 L-78 / LS-6 part(s) WANTED & Comments
 

I dont expect anyone to loan me (anything) a CLIP, but I'd like to try and find a vendor to repop that and the(also very rare) TCS wire clip used on 70+ Z-28 ignition wire(right rear lower valve cover bolt)support brkt.....
Chuck

Re: 1970 L-78 / LS-6 part(s) WANTED & Comments
 

Hey Chuck post a pic of the TCS clip...

Re: 1970 L-78 / LS-6 part(s) WANTED & Comments
 

Not sure, but the assembly manual drawing of the driver side smog pipe tree looks like my 69 big block with A/C tree, which I got from Bill Hodel, for my 69 Camaro

Re: 1970 L-78 / LS-6 part(s) WANTED & Comments
 

This CLIP is extremely RARE, along with other SMOG parts that were tossed. Anybody have a good idea as to WHAT company could repop these.....
Chuck


http://img.photobucket.com/albums/v4...r70Z28/TCS.jpg
http://img.photobucket.com/albums/v4...TempSender.jpg

Re: 1970 L-78 / LS-6 part(s) WANTED & Comments
 

Chuck
Can you tell me the Part# that the assembly manual or anyother source states that this RARE TCS clip is?
That looks VERY similar to a clip used on another chevy application.