Rebuilding 186 heads. Need source for parts.
 

I have a set of bare 186 heads that I need to get built. I am going with Manley valves but was wondering if there were any recommendations for springs and rocker arms. These are for the 302.

Re: Rebuilding 186 heads. Need source for parts.
 

We used the stock pressure 302 springs from Manley. I also used the roller TIP rockers from Crane. They fit under the valve covers. Just do a little cleaning in the ports and runners, shim your spring heights and use steel clips and retainers. Will go to 7000 rpm's all day. Sam

Re: Rebuilding 186 heads. Need source for parts.
 

Thats ok Sam.....Darrens car has never seen over a 5,000 rpm rev.... https://www.yenko.net/ubbthreads/imag...mlins/haha.gif

Re: Rebuilding 186 heads. Need source for parts.
 

That hurts.

Re: Rebuilding 186 heads. Need source for parts.
 

Below the belt that comment HUH! https://www.yenko.net/ubbthreads/imag...mlins/haha.gif https://www.yenko.net/ubbthreads/imag...mlins/haha.gif I get ya Frankie!!! https://www.yenko.net/ubbthreads/imag...emlins/eek.gif