1966 Hemi Charger HELP!
 

I'm in the process of a total "Upper End" rebuild on my 1966 Dodge Hemi Charger. It still retains its original 426/425 Elephant engine.

Question: Although the factory, stock pushrods look decent, I am contemplating replacing them. Before I go any further, could one of the forum members please describe for me what are the "factory standard pushrods"--diameter, lengths , etc for both the intake and exhaust valves.

Question: Is there anything on the market that is better than the stock pushrods, recalling that I'm keeping everything pretty much "standard"? The cam and crank are unchanged. I did install new valves, valve guides, springs and rocker arm assemblies but all to OEM standards and I did "hardened" the valve seats.

Last Question: When all is put back together, what are the correct intake and exhaust valve lashings?

Many Thanks,

Rick

PS: I also "posted" in the technical section. I really wasn't 100% sure where the correct posting should occur--sorry for any confusion or protocol breach!

Re: 1966 Hemi Charger HELP!
 

Heres a page out of my 1979 federal mogul parts catalogue.https://www.yenko.net/ubbthreads/pics...3-img_0770.jpg

Re: 1966 Hemi Charger HELP!
 

Yep, .028 and .032 cold.

Send me a PM with your address and I will send you a copy of the Sun Electric Corp. Tune up card from 1966, front and back.
Incredible amount of information.

Re: 1966 Hemi Charger HELP!
 

PM sent.

Rick