Connecting Rods
 

I want to use original BBC 3/8" connecting rods for my 396 build.

My question: Are the good 3/8" truck rods made of the same material or as strong as a 3/8" dimple rod?

I have a set of the truck rods and have no problem having them resized and updated.

FWIW...I won't use any rods made in China! https://www.yenko.net/ubbthreads/imag...mlins/hmmm.gif

Thanks, Kurt

Re: Connecting Rods
 

Just use your 3/8 stock rods resized with some good bolts you will not have any problems, as in any good rebuild balance your rotating assembly

Re: Connecting Rods
 

Thanks for the reply. https://www.yenko.net/ubbthreads/imag...lins/beers.gif

Re: Connecting Rods
 

[ QUOTE ]
Just use your 3/8 stock rods resized with some good bolts you will not have any problems, as in any good rebuild balance your rotating assembly

[/ QUOTE ]
I agree! Chevrolet had their act together by making every SBC, BBC, and W-Motor come with Forged connecting rods instead of cast iron construction like most Pontiacs and other manufacturers. Heck, even up until '67 or '68, almost every Chevy V-8 also had Forged steel crankshafts!

Re: Connecting Rods
 

I had a set of 7/16" rods lined up to purchased and was talking to someone who said that they are not necessary for the motor I am building...which I agree with.

Being that I have 2 sets of the HD 3/8 rods I will just have those gone through unless a set of dimple rods show up without breaking the bank.