The Supercar Registry

The Supercar Registry (https://www.yenko.net/forum/index.php)
-   Technical & Restoration (https://www.yenko.net/forum/forumdisplay.php?f=86)
-   -   Balancer question (https://www.yenko.net/forum/showthread.php?t=108589)

69L72RS 02-02-2010 03:51 PM
Balancer question
 
What is the ID tolerance limit for a 7708 balancer?
Thanks in adavance.
Eric

Lynn 02-03-2010 12:56 AM
Re: Balancer question
 
Not sure what you are asking. The damper is not a slip fit, so there should be no "tolerance". It is an interference fit (or press fit) and should measure slightly smaller than the crank snout.


All times are GMT. The time now is 09:55 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.


O Garage vBulletin Plugins by Drive Thru Online, Inc.