The Supercar Registry

The Supercar Registry (https://www.yenko.net/forum/index.php)
-   Technical & Restoration (https://www.yenko.net/forum/forumdisplay.php?f=86)
-   -   How to build a Camaro shell dolly?? (https://www.yenko.net/forum/showthread.php?t=108411)

iluv69s 01-22-2010 02:43 PM

How to build a Camaro shell dolly??
 
I know I saw a post with some plans on how to build a dolly to roll an early Camaro shell around. But the plan I saw was extremely intricate. I am not taking the shell totally apart. I just want to be able to move/store it easily. Does anyone have some 'simple' plans or fotos? I have purchased the steel and wheels...I just need to get welding....
I was trying to plan a dolly that I could easily remove and replace the subframe and rear without a lift....

or better yet, does anyone sell one?? any help would be greatly appreciated !! Thanks in advance !

396L35 01-22-2010 05:35 PM

Re: How to build a Camaro shell dolly??
 
I've been floating my shell on a rotisserie for the last 6 months but I know of a body shop that used a universal car dolly from Eastwood. You could make a cheap dolly system by attaching two brackets in the rear at the frame rails where the leaf springs attach and then make a set for the front and bolt them to the front body frame mounts. Total cost should be around $100 to $150 and it all depends on the size of the square stock you use. Good luck, Mark


All times are GMT. The time now is 12:58 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.


O Garage vBulletin Plugins by Drive Thru Online, Inc.