68 Yenko wheel
 

What is the code for the Pontiac rally used on the 68 Yenko Camaro? https://www.yenko.net/ubbthreads/imag...s/confused.gifThanks Jeff

Re: 68 Yenko wheel
 

Any help for this guy, folks? My guess would be that any Rally II wheel would work...am I close??

BTW: where in Show-Me land are ya? I'm down in the hills/curves...

Re: 68 Yenko wheel
 

What center caps did Yenko use on these cars?

Re: 68 Yenko wheel
 

THEY MOST LIKELY USED A 14X6 68 GTO/FIREBIRD WHEEL WHICH HAS THE CODE [JC] AND I BELIEVE THEY CHANGED THE INSERTS WITH A SPECIALLY MADE ONE. https://www.yenko.net/ubbthreads/imag...lins/beers.gif

Re: 68 Yenko wheel
 

I have some misc Pontiac ralleys. I can check the codes for you acelr8 if you need some.

Re: 68 Yenko wheel
 

I have some jc wheels

Re: 68 Yenko wheel
 

I am near Columbia and I do need 4 or 5,Thanks Jeff https://www.yenko.net/ubbthreads/imag...ns/burnout.gif

Re: 68 Yenko wheel
 

[ QUOTE ]
THEY MOST LIKELY USED A 14X6 68 GTO/FIREBIRD WHEEL WHICH HAS THE CODE [JC] AND I BELIEVE THEY CHANGED THE INSERTS WITH A SPECIALLY MADE ONE. https://www.yenko.net/ubbthreads/imag...lins/beers.gif

[/ QUOTE ]

While I don't know what the codes were, i was told that the wheels were 7 inches wide, and were selected because it was the cheapest 7 inch wide "mag style" wheels that Yenko could purchase. The center cap was specially made with a red "Y" instead of the PMD logo. No trim rings were used.
https://www.yenko.net/attachments/195448-ebaypics666.jpg

Re: 68 Yenko wheel
 

The JC was for a drum brake car. It would not clear the 4 piston calipers that were on the front of the 68 Yenko's.
The right wheel should have been a JA coded wheel GM# 525708 which also was a 14x6. I don't show a 14x7 Rally-II being available in 1968.