69 z stripe
How far down did the stripe come down on the header panel to the in side
|
I am sure that varied on the painter?
|
Are you talking about the stripes wrapping around the leading edge of the front header panel?
Usually about a 3/16 +/- is blown under the edge with most painters passing along the front edge. I don't think factory header panels were much different and likely varied as Sam stated. Once the grill stiffener is in you can't see beyond 1/4" or so. Mine ended just before the grill stiffener when looking from underneath and I think this was normal practice. https://i.ibb.co/HHy5WLW/IMG-3490.jpg |
If you mean on the engine compartment side, on my VN car the black stripes extended all the way down to the bottom edge of the header panel.
|
All times are GMT. The time now is 07:15 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.