67 Firebird LH traction bracket
 

Wanting to purchase the driver's side floor plate spot welded to the body (example as shown in attached picture) and the corresponding bracket which bolts to the two studs which protrude through the bottom of the floor. These are usually found on 400 Firebirds or some 326 4-speed cars. Thank you.

-Jon

Re: 67 Firebird LH traction bracket
 

I have an excellent complete LH and RH tractions bars with all original plates and bolts. I will take $300 shipped to lower 48.

Sorry, I do not want to separate

Re: 67 Firebird LH traction bracket
 

PM sent.

Re: 67 Firebird LH traction bracket
 

PM response.

Re: 67 Firebird LH traction bracket
 

Did not know there was a L& R bar. https://www.yenko.net/ubbthreads/imag...iggthumpup.gifLearn something new everyday.

Re: 67 Firebird LH traction bracket
 

I did not know either until I parted a 67 400-4spd bird.The bars are like little I-beams too..not round or square.Seems like they would hook up....and probably rarer than a 67 camaro traction bar rear

Re: 67 Firebird LH traction bracket
 

I'm still looking for those LH brackets if anybody has them or knows somebody who does.

Thanks,
-Jon

Re: 67 Firebird LH traction bracket
 

I have one ,but I thought it was just a R hand, fitting under the pass side like the camaro. Let me go look. Kim

Re: 67 Firebird LH traction bracket
 

I have the rod and the bracket that bolts to the rear end has casting # 978980 which one is this one L or R ?

Re: 67 Firebird LH traction bracket
 

Not sure. Can you post a picture of it?

-Jon

Re: 67 Firebird LH traction bracket
 

Sure

Re: 67 Firebird LH traction bracket
 

#2

Re: 67 Firebird LH traction bracket
 

#3

Re: 67 Firebird LH traction bracket
 

The 9789807 is the driver's side one and the 9789807 is for the passenger side. Can you make out another number on your bracket at the end?

What I am looking for is the floor plate that gets spot welded into the inside of the car on the driver's side and has the two studs that protrude through underneath. I am also looking for the corresponding bracket which bolts up to the driver's side floor bracket from underneath.

-Jon

Re: 67 Firebird LH traction bracket
 

Jon, I don't see any other #s https://www.yenko.net/ubbthreads/imag...lins/dunno.gif

Re: 67 Firebird LH traction bracket
 

Kim,

Sorry. I meant to type 9789808 is for the passenger side. Thanks for taking another look at yours.

-Jon

Re: 67 Firebird LH traction bracket
 

Is that the same floor plate that is in a 67 camaro.

Re: 67 Firebird LH traction bracket
 

The RH floor plate is the same design in a '67 Camaro and a Firebird. The LH floor plate was only available as original equipment in some models of the Firebird.

-Jon

Re: 67 Firebird LH traction bracket
 

Again, I learned something new. Thanks for the info. https://www.yenko.net/ubbthreads/imag...iggthumpup.gif

Re: 67 Firebird LH traction bracket
 

You're welcome, Kim. https://www.yenko.net/ubbthreads/imag...mlins/grin.gif

-Jon

Re: 67 Firebird LH traction bracket
 

Saw this ad on Racing Junk. Might be too far for you.
Ad #1665473. Doesn't cost anything to look.

Re: 67 Firebird LH traction bracket
 

Ad #1665143 Posted:2009-09-26 20:34:34
This ad expires in 80 days.
67-69 Camaro Hotchkis springs, Fbird rear



Hotckis 2 inch lowering springs for 67-69 Camaro sbc and 67-69 Firebird. 600lb rating, $100
1967 Firebird stock rear. Factory traction bar complete with all brakets and mounting. This is a non posi rear, do not know gears, will find out for Serious buyer. Right out of car cut up for parts. $350
Seller Phone Number: (717)247-2309

Seller Phone Number2: (717)247-2309
There is a picture if you can use the search.