Re: COPO Pete in "Drag Racer Mag"
 

[ QUOTE ]
Also...they said that they were going to restore an LS6 El Camino during the season...is that the El Camino that's owned by Dave C. now?

[/ QUOTE ]


Charley...do you know if this is the same LS6 El Camino? https://www.yenko.net/ubbthreads/imag...lins/dunno.gif

Re: COPO Pete in "Drag Racer Mag"
 

Great story https://www.yenko.net/ubbthreads/imag...iggthumpup.gif

Re: COPO Pete in "Drag Racer Mag"
 

From 3rd page of the article:

[ QUOTE ]
... Simpson's ZL1 still retains the stock 7.5x15-inch steel safety rims, which roll on a set of F70-14 Goodyear Polyglas bias ply tires...

[/ QUOTE ]

That seems like quite an accomplishment in itself.

Re: COPO Pete in "Drag Racer Mag"
 

https://www.yenko.net/ubbthreads/imag...lins/smirk.gif Dang! Another racing secret out! https://www.yenko.net/ubbthreads/imag...lins/dunno.gif https://www.yenko.net/ubbthreads/imag...ns/naughty.gif
Peter

Re: COPO Pete in "Drag Racer Mag"
 

Ha!

Re: COPO Pete in "Drag Racer Mag"
 

[ QUOTE ]
Ha!

[/ QUOTE ]

Hey, Charley has that saying copyrighted (like "Where's the Beef?") https://www.yenko.net/ubbthreads/imag...ins/tongue.gif

Re: COPO Pete in "Drag Racer Mag"
 

Pete,

The article says that you are running a cast iron block. Is that correct?


BW

Re: COPO Pete in "Drag Racer Mag"
 

Nope. One of the few mistakes in the article. (also not running F70-14 poly's on 7x15 rims either! https://www.yenko.net/ubbthreads/imag...mlins/grin.gif) But other than that, pretty accurate article!
Peter

Re: COPO Pete in "Drag Racer Mag"
 

Lots of dish soap to get those tires on the rims. LOL!

Jim