Re: 68 BM Phase III L-88 Progress Update
 

Can't beat the look of those bare aluminum heads.

Re: 68 BM Phase III L-88 Progress Update
 

Intake is now too thick at the front and rear. 50 K will need to be shaved off to make the fit. [img]/ubbthreads/images/graemlins/rolleyes.gif[/img]

Re: 68 BM Phase III L-88 Progress Update
 

That news isn't all that bad...sounds like the heads/block have had material removed, which should bump the compression up closer to it's as advertised number and help performance. Cool! [img]/ubbthreads/images/graemlins/biggthumpup.gif[/img] And if that's the case, the stock pushrods may be too long...just something to check.

Re: 68 BM Phase III L-88 Progress Update
 

Rob,

Thanks. We are proceeding SLOWLY. So far so good....

Phil

Re: 68 BM Phase III L-88 Progress Update
 

Phil:

Those aluminum heads will definitely make the slower pace worth every minute! [img]/ubbthreads/images/graemlins/biggthumpup.gif[/img]

Re: 68 BM Phase III L-88 Progress Update
 

Putting some marks on the balancer to finish up the valve adjustment...... [img]/ubbthreads/images/graemlins/no.gif[/img]

Re: 68 BM Phase III L-88 Progress Update
 

Valve adjustment complete... [img]/ubbthreads/images/graemlins/no.gif[/img]

Re: 68 BM Phase III L-88 Progress Update
 

Jim taking a break and reading about Joel's A/MP 466 inch L-88 Camaro build up in 68..... [img]/ubbthreads/images/graemlins/scholar.gif[/img]

Re: 68 BM Phase III L-88 Progress Update
 

After much sweat and 60K off of the front and rear bottoms of the intake it lines up- kinda..... [img]/ubbthreads/images/graemlins/naughty.gif[/img]

Re: 68 BM Phase III L-88 Progress Update
 

View from the other side. Job is literally a hand fit due to the head work that was completed previously. [img]/ubbthreads/images/graemlins/rolleyes.gif[/img]