Forum: Lounge
10-03-2024, 01:35 AM
|
Replies: 1,010
Views: 463,936
|
Forum: Member's Rides
09-09-2024, 01:04 AM
|
Replies: 182
Views: 105,178
Thanks to some mice
This is one that is a first for me. Upon doing some window channel sand blasting i found the package tray area undeer the dutchman panel was pinholes from rust. After investigating and blowing out...
|
Forum: Parts/Memorabilia - For Sale
09-06-2024, 08:35 PM
|
Replies: 2
Views: 283
|
Forum: Technical & Restoration
09-06-2024, 02:19 PM
|
Replies: 19
Views: 2,720
I always check the timing mark on a engine that...
I always check the timing mark on a engine that I'm building using a piston stop before putting the heads on. I never trust it until I verify that it's correct. I even verify TDC on a running engine...
|
Forum: Member's Rides
09-02-2024, 01:31 PM
|
Replies: 182
Views: 105,178
Rough in Complete
After stripping its hammer out the dents, followed by the base layer of filler. I wanna point out that the better job of hammering out the dents the less filler you have which is the primary goal. ...
|
Forum: Lounge
08-14-2024, 01:44 AM
|
Replies: 34
Views: 4,346
|
Forum: Lounge
08-09-2024, 12:54 AM
|
Replies: 34
Views: 4,346
|
Forum: Lounge
08-08-2024, 10:32 PM
|
Replies: 34
Views: 4,346
|
Forum: Lounge
08-06-2024, 11:11 AM
|
Replies: 34
Views: 4,346
|
Forum: Nickey Chevrolet & Bill Thomas Performance
07-03-2024, 12:24 PM
|
Replies: 4
Views: 3,777
Big Thanks to Stefano!!
My daughter and I were at “Sick Week” drag and drive event at Byron Dragstrip several weeks ago and ran into Stefano.
He hooked her up with some Nickey swag.
Thanks again Stefano!:youguysrock:
...
|
Forum: Member's Rides
06-23-2024, 03:17 PM
|
Replies: 182
Views: 105,178
Color Spray Out and bunch of misc items
Weekend of running. zinc and yellow zinc plating done. Radiator being recored. Picked up some sample 72 paint for a color spray out test. Looks very close,
|
Forum: Chevrolet
06-20-2024, 10:21 PM
|
Replies: 12
Views: 4,895
|
Forum: Parts/Memorabilia - For Sale
06-20-2024, 01:57 PM
|
Replies: 2
Views: 784
|
Forum: Ebay & other seen ads section
06-19-2024, 03:34 AM
|
Replies: 7
Views: 3,398
|
Forum: In Memoriam
05-31-2024, 03:52 AM
|
Replies: 14
Views: 6,314
Cliff Ernst
https://www.hendersonvillefh.com/obituaries/clifford-ernst
|
Forum: Ebay & other seen ads section
05-28-2024, 07:23 PM
|
Replies: 7
Views: 2,682
No strike at Norwood.
Fisher Body skipped...
No strike at Norwood.
Fisher Body skipped 02C; 02D builds span 18 production days and almost 13,000 units.
Van Nuys was on strike April 28-June 18. The last 1,000 or so units were a mix of 04D...
|
Forum: Auctions
05-25-2024, 03:53 PM
|
Replies: 12
Views: 4,291
|
Forum: Lounge
05-22-2024, 08:41 PM
|
Replies: 23
Views: 10,410
I HAD all air stuff over the years, lines and...
I HAD all air stuff over the years, lines and outlets all over the garage, but now I have 18v Milwaukee impacts/sockets and these things are animals. I can just leave them on the workbench for weeks...
|
Forum: Auctions
05-22-2024, 12:31 AM
|
Replies: 40
Views: 17,080
|
Forum: Pontiac
05-19-2024, 01:48 PM
|
Replies: 21
Views: 9,131
|
Forum: Supercar/Musclecar Discussion
05-12-2024, 09:27 PM
|
Replies: 103
Views: 53,277
|
Forum: Ebay & other seen ads section
05-12-2024, 07:43 PM
|
Replies: 23
Views: 5,918
|
Forum: Supercar/Musclecar Discussion
05-08-2024, 03:48 PM
|
Replies: 17
Views: 5,842
|
Forum: Yenko Chevrolet
05-08-2024, 10:11 AM
|
Replies: 15
Views: 11,869
We have updated the registry to include...
We have updated the registry to include appropriate information regarding the "nutmeg" car for the next posting. It was delivered new at Yenko Chevrolet and later presented as a dealer conversion,...
|
Forum: Yenko Chevrolet
05-07-2024, 12:35 AM
|
Replies: 24
Views: 11,012
Hi Steve!
I read through the discussion and...
Hi Steve!
I read through the discussion and don't really see any 'new' information about this particular Nova. The story has been that the orig owner ordered it with additional options and...
|